Features Robust steel body Powder coated paint finish High quality SABS stamped control gear Heat resistant wiring Versatile (interchangeable light controllers) Tubes and control gear easily accessible Easy to install SABS IEC 60598 safety approved

Finishes Body

The steel is subjected to a process of degreasing, derusting and phosphating. Where after it is coated with a backed epoxy powder. Sufficient knockouts are provided for 20mm conduit entries.

Clip in Prismatic Diffuser

The aluminium framed acrylic prismatic diffuser provides an attractive square modular light controller to enhance any installation. Fitted with gasket.

Applications

This very decorative luminaire is designed to enhance the appearance of a ceiling with a surface lighting installation. Areas with open beam structure, plaster board and concrete ceilings are perfect applications for this light fitting.

Specification

• Body is manufactured from cold rolled mild steel with thermo-setting epoxy powder finish.
• Louvre is securely fitted to the body of the luminaire so that it cannot in any way become dislodged.
• Screwless push-in lampholders with a centre rotor pin support must be used.
• Starters to suit the 26mm energy saving tubes, chokes and capacitors that carry the SABS mark form part of the total electrical circuit.
• An earth tag forms part of the overall body for good continuity.

Sizes